|
[Sponsors] |
May 4, 2007, 10:11 |
Unable to open window, exceed message
|
#1 |
Guest
Posts: n/a
|
Hello there, i have installed exceed and gambit and although exceed starts i get an error saying it can't open window of gambit. Any suggestions.
Regards, Achilleas Tsompanos |
|
May 4, 2007, 12:56 |
Re: Unable to open window, exceed message
|
#2 |
Guest
Posts: n/a
|
Please, report all the error message.
thomas |
|
May 5, 2007, 11:55 |
Re: Unable to open window, exceed message
|
#3 |
Guest
Posts: n/a
|
This happens when your firewall blocks internet access from Gambit. You don't even need the cable in as long as Gambit thinks it has internet access.
It could of course be a different problem completely so if this doesn't work then I agree with Thomas. |
|
May 9, 2007, 09:32 |
Re: Unable to open window, exceed message
|
#4 |
Guest
Posts: n/a
|
The message is "unable to open window". However the exceed control panel shows up.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit error: Cannot find exceed x server | Jake | FLUENT | 6 | September 10, 2011 11:43 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Error message in CFX-10 | CFDworker | CFX | 2 | October 12, 2007 07:23 |
OPEN MESSAGE TO WEBMASTER | caloggero | FLUENT | 3 | December 4, 2004 20:11 |
Gambit error : Unable to find Exceed X Server | Jarod | FLUENT | 2 | November 4, 2004 06:41 |