 |
 |
 |
|
|
|
[Sponsors] | ||||
April 25, 2007, 16:36
|
Porous Jump
|
#1 |
|
Guest
Posts: n/a
|
Hi Fluent users
What is the physical meaning of 'Porous Jump' in fluent? Fluent manual says its like a 1D membrane. There is no adequate explanation for properly modeling fluid flows where porous jump conditions are involved. 1. How can we model C0 or C1 discontinuity for species concentration at the interface (porous jump)? 2. How can we model velocity or pressure discontinuity for species concentration at the interface (porous jump)? Any suggestions would be good. Thanks |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How can I define different zones in ICEM? | llrr | ANSYS Meshing & Geometry | 14 | February 12, 2017 14:44 |
| [Commercial meshers] Porous Jump creation problem | mulfal | OpenFOAM Meshing & Mesh Conversion | 4 | December 9, 2013 12:59 |
| Porous jump in urban environment | samygero | FLUENT | 0 | February 14, 2011 19:26 |
| Porous jump & Porous zone - help needed | Witsarut Jintaworn | FLUENT | 3 | June 14, 2010 23:37 |
| Testing the integrity of POROUS media and por jump | Azman | FLUENT | 0 | July 31, 2006 12:11 |
Linear Mode
