Large U-tube modeing and meshing.

April 8, 2007, 21:34

Hi, am modeling a U-tube, the size of which is 175m (length) and 48mm (diameter). Because of this highly disproportionate size I am not able to model the tube. And when it comes to meshing then it is rahter more difficult. Can you please tell me a way to model the problem?

thanks!!!

April 17, 2007, 04:08

Hi pradeep,

I belevie it should not be a problem in meshing the volume.

It should be pretty much straight forward.

Thanks Regards Rohan

April 8, 2007, 21:34	Large U-tube modeing and meshing.	#1
Pradeep Guest Posts: n/a	Hi, am modeling a U-tube, the size of which is 175m (length) and 48mm (diameter). Because of this highly disproportionate size I am not able to model the tube. And when it comes to meshing then it is rahter more difficult. Can you please tell me a way to model the problem? thanks!!!

April 17, 2007, 04:08	Re: Large U-tube modeing and meshing.	#2
Rohan Guest Posts: n/a	Hi pradeep, I belevie it should not be a problem in meshing the volume. It should be pretty much straight forward. Thanks Regards Rohan