error in meshing

April 5, 2007, 16:23

i just installed gambit2.2.30. while exporting the *.msh file it says "ERROR: continuum or boundary condition on edge.4 is invalid for fluent 6" when i use fluent5/6 as the solver but not when i use some other solver...... also i didnt have this problem when i used earlier version of gambit2.04...

plzzzzz helppppppp

April 9, 2007, 06:36

just try changing the boundary to wall for example and see if it reads it.

what kind of boundary is edge 4 just now? are you sure it can be used that way in fluent?

YOU MIGHT HAVE e.g. SET EDGE TO WALL IN 3D MODEL WHERE ONLY FACES SHOULD BE WALLS.

April 5, 2007, 16:23	error in meshing	#1
Ankit Guest Posts: n/a	i just installed gambit2.2.30. while exporting the *.msh file it says "ERROR: continuum or boundary condition on edge.4 is invalid for fluent 6" when i use fluent5/6 as the solver but not when i use some other solver...... also i didnt have this problem when i used earlier version of gambit2.04... plzzzzz helppppppp

April 9, 2007, 06:36	Re: error in meshing	#2
Phil Guest Posts: n/a	just try changing the boundary to wall for example and see if it reads it. what kind of boundary is edge 4 just now? are you sure it can be used that way in fluent? YOU MIGHT HAVE e.g. SET EDGE TO WALL IN 3D MODEL WHERE ONLY FACES SHOULD BE WALLS.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 06:22
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 12:08