 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2007, 12:33
|
floating point
|
#1 |
|
Guest
Posts: n/a
|
hi
i am trying to simulate two phase flow with heat transfer. when i try to start a simulation apears an erorr. it says: Floating point error: invalid number What does it mean floating point erorr and how to correct the inputs. thanx |
|
|
||
|
February 28, 2007, 11:03
|
Re: floating point
|
#2 |
|
Guest
Posts: n/a
|
||
|
|
||
|
February 28, 2007, 14:10
|
Re: floating point
|
#3 |
|
Guest
Posts: n/a
|
to long time steps, not enougt iterations per time step, some errors in boundary conditions (like , in case of . - I had such problem with , and. beetwen numbers). Please use search. There was such problem on forum many times ...like Ralf said. best wishes
|
|
|
|
||
|
March 2, 2007, 02:47
|
Re: floating point
|
#4 |
|
Guest
Posts: n/a
|
ok. i found it. thank you for the answers.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 17:34 |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 05:59 |
| reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 18:29 |
| Floating point exception error with small DeltaT | rassilon | OpenFOAM Running, Solving & CFD | 19 | September 2, 2009 08:39 |
| [Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
Linear Mode
