How to set two inlet boundary condition???Plz help

February 20, 2007, 04:42

Hi all;

I have two inlet boundary condition, pressures and velocities in inlet have a specified value;For example : Pin1=10barg,Vin1=10m/s. Pin2=05barg,Vin2=05m/s.

How to adjust fluent setting for this case? Should I use a UDF for this case? have you an example or a tutorial like as this case?

Thanks in advance for any help.

shahid nadeem · October 17, 2013, 14:45

hello

i dont think we can apply two inlet conditions, atleast i have not used it. however if you get to know about it then tell me too

February 20, 2007, 04:42	How to set two inlet boundary condition???Plz help	#1
asghari Guest Posts: n/a	Hi all; I have two inlet boundary condition, pressures and velocities in inlet have a specified value;For example : Pin1=10barg,Vin1=10m/s. Pin2=05barg,Vin2=05m/s. How to adjust fluent setting for this case? Should I use a UDF for this case? have you an example or a tutorial like as this case? Thanks in advance for any help.

October 17, 2013, 14:45	2 inlet	#2
shahid nadeem Member Nazim Join Date: Oct 2013 Posts: 93 Rep Power: 13	hello i dont think we can apply two inlet conditions, atleast i have not used it. however if you get to know about it then tell me too

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mesh file for flow over a circular cylinder	Ardalan	Main CFD Forum	7	December 15, 2020 14:06
Problem with assigned inlet velocity profile as a boundary condition	Ozgur_	FLUENT	5	August 25, 2015 05:58
How to set the Heat Flux boundary condition at Outlet	creddy_trddc	CFX	3	September 21, 2011 08:44
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 11:56
transitional inlet boundary condition	kamp	CFX	1	June 21, 2006 12:08