Flash Tank Simulation -- CFD Online Discussion Forums

February 16, 2007, 02:21	Flash Tank Simulation	#1
Hamid Nabati Guest Posts: n/a	I'm going to simulate a special flash tank using Fluent software as a part of my thesis. The flash tank is used in a process line in the Alumina factory. I would like to know whether it is possible fundamentally to use Fluent for this purpose or not? the complementary informatoions are as following: 1- The raw material entering the flash tank is bauxite slurry(a mixture of milled bauxite, lime and weak caustic liquor) 2- Inlet T and P are:270 C, 5.74 Mpa 3- Flash tank pressure :4.41 Mpa

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Resume Transient simulation	HMR	CFX	1	June 28, 2011 22:13
Roll Tank Simulation	Sam	CFX	14	February 15, 2009 21:21
Continuous vs interrupted simulation	sega	OpenFOAM Running, Solving & CFD	4	November 3, 2008 15:29
Pressure BCs for rasInterFoam tank fillingdraining problem	kwardle	OpenFOAM Running, Solving & CFD	8	September 17, 2008 15:37
simulation of a stirred tank	hu	CFX	0	February 17, 2001 08:23

All times are GMT -4. The time now is 15:44.