|
[Sponsors] |
February 5, 2007, 02:33 |
Units?
|
#1 |
Guest
Posts: n/a
|
Hello all, I am running a number of automotive simulations and am particularly curious about the drag co-efficient force monitor. My value for this monitor is converging to a very large number, which doesn't really make any sense. I suspect it is because Fluent thinks my model is much larger than it really is. The area projection report function confirms this.
Does anyone have advice on how to check the scale of my model and adjust it accordingly? Thanks for all the help in the past, I am finally having more regular success using Fluent thanks to all of you. best Skander |
|
February 5, 2007, 10:10 |
Re: Units?
|
#2 |
Guest
Posts: n/a
|
Grid->Scale
Good luck, Jason |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDS source term units | Ale | FLUENT | 3 | March 29, 2017 08:08 |
units in OpenFOAM | megacrout | OpenFOAM | 4 | July 19, 2011 09:04 |
units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 04:58 |
Mass transfer units in fluent | nite_surfer | FLUENT | 0 | July 12, 2007 13:51 |
Units for Contaminant Concentration | Rob | Phoenics | 1 | March 30, 2005 11:06 |