|
[Sponsors] |
General question regarding Fluent 6.3s mesh motion |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 8, 2006, 13:01 |
General question regarding Fluent 6.3s mesh motion
|
#1 |
Guest
Posts: n/a
|
Hi all,
We are looking at using Fluent 6.3 for a butterfly valve simulation (carburettors). I know that fluent is capable of modelling reciprocating engine fluid dynamics with linear valve actuation. However we need a mesh motion model that can handle the following: -Butterfly disk completely cuts off flow and seals main bore while flow can still bypasses the sealed valve via other remote labyrythine passages (i.e. upstream to downstream fluid communication via other channels still occurs). -We need to model many cycles of valve opening and closure contiguously. This implies that we need a CFD code that can: -Handle domain pinch off (i.e. complete valve closure splitting the previously connected domain) -Handle combined translational and rotational motion by rigid bodies within the domain. -Handle domain merging (i.e. when valve starts to reopen the domains must re-merge) Can Fluent 6.3 handle this? Any suggestions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] export hexa mesh to fluent | Wieland | ANSYS Meshing & Geometry | 37 | January 23, 2013 04:27 |
Exporting structured mesh from ICEMCFD to Fluent? | jeevan kumar | FLUENT | 1 | January 23, 2012 12:21 |
a mesh motion question | womo | CFX | 5 | March 16, 2011 11:54 |
FLUENT dynamic mesh set-up question | ral007 | FLUENT | 0 | February 15, 2011 13:28 |
where do you find Mesh Motion command in fluent | san | FLUENT | 1 | March 18, 2006 11:26 |