|
[Sponsors] |
Cylindrical combustion chamber expanding mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 19, 2006, 09:34 |
Cylindrical combustion chamber expanding mesh
|
#1 |
Guest
Posts: n/a
|
Hi,
I am trying to model a cylindrical combustion chamber which increases in radius over time to simulate the effects of fuel regression but I can't figure out how. Ive been through the Fluent manuals loads to try and figure out how to do it but it seems that Fluent is only capable of simple linear motion with regards to moving meshes. Is it a sliding or dynamic mesh I need and can it be done without writing a UDF? Any response would be most appreciated. Neil |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
I can not achieve ignition in combustion chamber. | hectordiaz | FLUENT | 0 | June 6, 2011 06:38 |
setfileds for cylindrical mesh | aki_yafuji | OpenFOAM | 3 | December 9, 2010 22:35 |
Guides for calculation of mesh size for combustion | Luk | CFX | 4 | March 17, 2008 03:34 |