|
[Sponsors] |
October 13, 2006, 11:51 |
Wall Boundary Flux : positive or negative ?
|
#1 |
Guest
Posts: n/a
|
Hi, Is it correct to state that the face normal A (F_AREA(A,f,tf)) of a boundary face always points outwards of the domain ? Reading the UDF-manual can sometimes be a little confusing. I'm dealing with UDS-scalars, and some values need to cross some boundaries, either inlet or outlet. I assume that it is a question of giving the correct sign to the boundary profile (+ of -) ? Thanks in advance.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 08:57 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
Deal with wall boundary with moving mesh by FVM? | aiya | Main CFD Forum | 6 | May 10, 2007 12:33 |
applying boundary condition on rotating wall | Haris Maharana | Siemens | 2 | January 16, 2001 13:03 |