 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2006, 07:50
|
Split a mesh
|
#1 |
|
Guest
Posts: n/a
|
Hi everyone,
I´m woorking with a 3d mesh, in fluent but i can, only, see the contours in the surfaces of the object, after run the programm. I would like to split the oject in half so that I can see the the flow evolution inside the object. Does anyone knows how can I do it? Thanks |
|
|
||
|
October 5, 2006, 05:00
|
Re: Split a mesh
|
#2 |
|
Guest
Posts: n/a
|
Cut quadric surface or iso surface where you want to see the countoures.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
| [ICEM] Split wall hexa mesh | Anorky | ANSYS Meshing & Geometry | 2 | March 21, 2010 11:33 |
| 2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 05:49 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
| basic of mesh refinement | arya | CFX | 4 | June 19, 2007 13:21 |
Linear Mode
