Extracting 2d geometry from 3d in Gambit

September 11, 2006, 08:57

Hi

I need to extract a 2D slice from a complex 3D geometry in Gambit. Any tips on the best way to do this would be greatly appreciated.

Thanks,

Mike

September 11, 2006, 09:32

cut your 3d-geometry with a plane (surface). The section will be your slice. Then delete all the volumes, BUT check that "lower Geometry" is NOT enabled. Then delete all the faces except your slice. That's it!

September 11, 2006, 11:24

Thanks mAx,

I tried this several times before asking the question but without success, however after persevering it appears to have worked!

Thanks again,

Mike

September 11, 2006, 08:57	Extracting 2d geometry from 3d in Gambit	#1
Mike Guest Posts: n/a	Hi I need to extract a 2D slice from a complex 3D geometry in Gambit. Any tips on the best way to do this would be greatly appreciated. Thanks, Mike

September 11, 2006, 09:32	Re: Extracting 2d geometry from 3d in Gambit	#2
mAx Guest Posts: n/a	cut your 3d-geometry with a plane (surface). The section will be your slice. Then delete all the volumes, BUT check that "lower Geometry" is NOT enabled. Then delete all the faces except your slice. That's it!

September 11, 2006, 11:24	Re: Extracting 2d geometry from 3d in Gambit	#3
Mike Guest Posts: n/a	Thanks mAx, I tried this several times before asking the question but without success, however after persevering it appears to have worked! Thanks again, Mike

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Geometry of Tank and Rushton Turbine in Gambit	jawidnaik	ANSYS Meshing & Geometry	1	February 4, 2015 08:28
create turbine geometry with gambit	badlaine	ANSYS Meshing & Geometry	2	March 27, 2012 00:54
[GAMBIT] meshing in GAMBIT, a flow through a pipe having complex inflow geometry	mazhar1613	ANSYS Meshing & Geometry	1	January 12, 2012 00:18
What can I employ to create geometry besides Gambit?	summer	ANSYS Meshing & Geometry	2	February 11, 2011 15:50
problem about Importing geometry in Gambit	Hua Gu	FLUENT	3	April 2, 2002 15:24