Meshing aerofoil -- CFD Online Discussion Forums

June 19, 2006, 06:08	Meshing aerofoil	#1
Sajal Sengupta Guest Posts: n/a	Hello everybody, I'm doing project under hydrofoil\aerofoil.I'm following cornell university guide (analysis of flow over aerofoil). (http://instruct1.cit.cornell.edu/cou.../airfoil/index) Previously programm was stoped during meshing aerofoil edges in gambit when i clicked "last length" obtion. Multiplying coordinates of aerofoil by 10 this problem overcame but again program clashes when I'm multiplying my previous data by 10 in "interval count" obtion .plz help me.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] 2d Aerofoil meshing in ansys ICEM	syler3321	ANSYS Meshing & Geometry	2	February 3, 2012 02:59
Aerofoil meshing	eugene	Main CFD Forum	1	September 7, 2008 01:11
digitizing an aerofoil/ meshing problems	Simon	FLUENT	2	February 27, 2006 12:18
Meshing an aerofoil with a plain flap	Fatou	FLUENT	0	November 15, 2005 15:24
Icem Hexa 2d aerofoil meshing	Ste Lakey	CFX	0	August 25, 2004 08:05

All times are GMT -4. The time now is 12:14.