About the scales of mesh in DES? -- CFD Online Discussion Forums

June 17, 2006, 11:02	About the scales of mesh in DES?	#1
lcw Guest Posts: n/a	when I use the detached eddy simulation(DES), how do I choose the scale of mesh? especially near wall. If I choose 2mm of each mesh, does this satisfy the requirement of DES? Would you give me some advices? Thank you very much. LCW

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 06:25
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 19:10

All times are GMT -4. The time now is 01:05.