|
[Sponsors] |
June 3, 2006, 19:39 |
Not to display warnings?
|
#1 |
Guest
Posts: n/a
|
Hi everyone: I'm trying to do some simulations in FLUENT and I'm getting "reverse flow" or "turbulence viscoity ratio ..." warnings. Does anyone have any idea how to avoid displaying them on the consule? I just want them not to be displayed cause displaying them makes the simulation time much longer.
Thanks in advance Yasser |
|
June 3, 2006, 22:49 |
Re: Not to display warnings?
|
#2 |
Guest
Posts: n/a
|
go into "/solve/set/flow-warnings?" in the fluent console (text user interphase) and then fluent will ask if you want to enable the flow warning messages. you can disable them by typing "no". good luck
|
|
June 4, 2006, 04:27 |
Re: Not to display warnings?
|
#3 |
Guest
Posts: n/a
|
Many thanks for your help. I've got rid of "reverse flow" warnings but I still get "turbulent viscosity limited to .....". Is there any way to hide them too? Thanks alot
Cheers, Yasser |
|
June 4, 2006, 09:27 |
Re: Not to display warnings?
|
#4 |
Guest
Posts: n/a
|
you can ignore them in "solve/set/limiter-warnings?"(no). But i doubt if u want to ignore the viscosity limiting warning. I usually get the viscosity warning at the starting of the simulations, just until the solution gets stabilized. If the warning still appears later too, then i think there might be a problem with the problem setup. think about it. gl
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problems with Fluent display windows | chris | FLUENT | 3 | January 7, 2016 11:44 |
Problem with paraFoam | ata | OpenFOAM | 14 | November 30, 2009 05:23 |
free surface display | carno | Siemens | 4 | October 7, 2005 02:03 |
lots of warnings | Arnab | Siemens | 2 | January 27, 2005 16:36 |
Display Reynold Stresses in K-E | Andrew | FLUENT | 4 | April 16, 2004 19:12 |