Home > Forums > Software User Forums > ANSYS > FLUENT

How can the water cut be Set into a pipe flowâ€Ž

Updated Threads

Reply

Search this Thread

June 1, 2006, 07:49	How can the water cut be Set into a pipe flowâ€Ž	#1
B Saleem Guest Posts: n/a	Hi Fluent users:&lrm; I have two phase (oil-water) flow into a pipe , water flow in the button of the pipe &lrm;and oil in the top. I have a problem to enter the amount of water cut in the pipe &lrm;which it (25%) , anyone kindly tell me how can I did that?&lrm; Thanks &lrm; Khalid &lrm;

June 1, 2006, 09:21	Re: How can the water cut be Set into a pipe flowâ	#2
HVN Guest Posts: n/a	You could use a patch

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[DesignModeler] DesignModeler Pipe within pipe	shields	ANSYS Meshing & Geometry	13	November 25, 2018 23:14
gambit code fluent on water pipe	acai007	FLUENT	0	August 29, 2010 22:53
How to set the water cut	KBS	FLUENT	1	June 8, 2006 06:42
How I set the water height by given water cut	KB Saleem	FLUENT	0	June 4, 2006 04:48
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 10:11

All times are GMT -4. The time now is 23:20.