|
[Sponsors] |
May 24, 2006, 18:09 |
Track a flow parameter on a point
|
#1 |
Guest
Posts: n/a
|
hey,
I am running an 2D unsteady case with a compiled UDF of an airfoil. I would like to monitor the vorticity right behind the trailing edge at a point A. So, I created a point A (Surface>point), but I want it move so that it remains at the same relative position to the airfoil, to which a UDF was prescribed. In that way, I can keep track of the vorticity magnitude at that point throughout the motion. Can anyone tell me how to make the point a as a zone so that I can hook the same airfoil UDF to it? Thanks a lot in advance. Astozzia |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Compressible flow, no data at the outlet | mireis | FLUENT | 6 | September 3, 2015 03:10 |
how to calculate flow properties along the first grid point near to the wall | kiran | OpenFOAM Post-Processing | 2 | September 12, 2010 13:59 |
Laminar Flow and Particle Track: Inconsistent? | Domenico | FLUENT | 0 | February 20, 2007 15:47 |
Particle track and digit after decimal point | Sumon | CFX | 0 | May 15, 2003 23:33 |