|
[Sponsors] |
May 19, 2006, 05:21 |
PLEASE HELP FOR UDF ITERATION!!!!
|
#1 |
Guest
Posts: n/a
|
Hello!
I really need help for this pb! I made an UDF and i store the number of iteration in a file. And I notice that the number of iteration make a loop between 500 and 1000 (begin to 500 and finish at 1000). So if I ask 700 iterationn the first iteration will be 500 and the last 200. To catch the number of iteration I use "nres".... I am also in a transient simulation. If somebody can tell me how to begin the with a value of 1 and don't be limited by 1000. For more information, I made an UDF that inject mass only at the begining of every time step. Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 02:54 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 23:30 |
Creating, loop or iteration using expression edito | Jan | CFX | 3 | July 28, 2003 12:01 |
Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 05:36 |