|
[Sponsors] |
May 10, 2006, 19:07 |
cavitation menu is not showing
|
#1 |
Guest
Posts: n/a
|
When I want to define the 'multiphase Model' only half of the pannel is showing. In other words the 'Interphase Mass Transfer' is Not showing so I can't not choose 'cavitation' and its parameters. Pls somebody help me on this problem. FYR I am a novice of Flunent.
|
|
May 11, 2006, 02:54 |
Re: cavitation menu is not showing
|
#2 |
Guest
Posts: n/a
|
Hi!
If you use Fluent 6.1 the menu should appear when you click on the "mixture model". In fluent 6.2 you must first set the mixture multiphase model then go to "Define-Phases" click on phase-1 and then click interaction. In the menu click "mass" and then click on "cavitation" - you define all the parameters here... Hope it helps MATEUS |
|
May 11, 2006, 13:43 |
Thanks a lot!
|
#3 |
Guest
Posts: n/a
|
Mateus, I used 6.1 manual with 6.2 s/w. You help me a lot Thanks.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plant Menu | Scott | Phoenics | 2 | October 6, 2006 05:51 |
compressibility and cavitation!! | xhliu1 | Siemens | 11 | March 16, 2005 08:19 |
Cavitation Simulation by CFD | Liu, L. | CFX | 2 | November 29, 2000 14:50 |
Cavitation Simulation by CFD | Liu, L. | Siemens | 2 | November 1, 2000 22:51 |
Cavitation Simulation by CFD | Liu, L. | Main CFD Forum | 7 | November 1, 2000 22:26 |