|
[Sponsors] |
can fluent capture BOUNDARY LAYER of POROUS zone? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 22, 2006, 08:14 |
can fluent capture BOUNDARY LAYER of POROUS zone?
|
#1 |
Guest
Posts: n/a
|
I am modeling Vertical flat plate for laminar natural convection in an infinite porous media.
But there's no boundary layer for velocity and temperature. The only case that will capture BOUNDARY LAYER is when porosity=1. There will be no boundary layer when porosity is smaller than 1.0. I want to know if FLUENT can capture boundary layer when there is POROUS MEDIA in the domain. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh | tomyangbath | FLUENT | 18 | October 12, 2016 07:57 |
Boundary layer profile at inlet for cavity study in fluent | uea | Main CFD Forum | 0 | May 14, 2011 14:01 |
[ICEM] Prism layer to capture the Boundary Layer | dfitz1000 | ANSYS Meshing & Geometry | 1 | March 10, 2011 04:34 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 14:47 |
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 16:02 |