 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2006, 22:03
|
DPM-aprticle escaped. What does that mean?
|
#1 |
|
Guest
Posts: n/a
|
When I run DPM, the following messsege appeared: tracked 1000, escaped 999, abort=1, incompelete=0. What does that mean? Thanks in advance.
|
|
|
||
|
March 8, 2006, 01:13
|
Re: DPM-aprticle escaped. What does that mean?
|
#2 |
|
Guest
Posts: n/a
|
First chech the following condtion Which fuel used What is the inilization temp. What is the fuel inlet temp what is air inlet temp. And where u give the injection There must me temp. such that it ignite so increse the temp of air or inilization MANOJKUMAR
|
|
|
|
||
|
March 8, 2006, 02:55
|
Re: DPM-aprticle escaped. What does that mean?
|
#3 |
|
Guest
Posts: n/a
|
check your DPM boundary conditions
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DPM modeling | Mohsin | FLUENT | 0 | March 31, 2010 23:11 |
| DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 02:29 |
| DPM - do the particles affect the liquid? | Nikhil Dani | FLUENT | 0 | January 1, 2009 12:58 |
| Interesting Injection result of DPM? | Rachel | FLUENT | 2 | July 8, 2008 19:00 |
| slow after mesh for enhanced wall treat DPM | joshkemp | FLUENT | 0 | May 1, 2007 18:20 |
Linear Mode
