I have a problem with Gambit GUI. My subpads are too narrow. I cant see some of the controls and I cannot change the subpad width by clicking on the edge of the subpad window and drag it. Is there any setting that I should provide for me to see the subpads properly.

Thanks in advance Derick

decrease the widht of the the gui (this window where you see the actual geometry being created and so on) before going to subpad. once this is done the remaining control sub pads will automatically reset to the new size of gui. This is a very fine division and u can find it out by slowly moving the cursor on the border of gui.

Regards

Hey Rizwan:

my problem is that the subpads that come up dont have all the menus completely visible. For example, if i open the form volume option, it gives me a sweep face form. This is not completely visible and some of the menus kind of cut out. I cannot reduce this size such that it totally appears on the screen.

Thanks in advance Derick