Home > Forums > Software User Forums > ANSYS > FLUENT

Temperature limit 1.00 k in cell

Updated Threads

Reply

Search this Thread

February 24, 2006, 09:13	Temperature limit 1.00 k in cell	#1
MANOJKUMAR Guest Posts: n/a	Hello, I doing injection and air temp is 650K and fuel is 303K and iterate then this above problem occur.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solution technique/ Mesh type/ Cell limit/ Multi-zone regions in CFX	zandi	CFX	5	April 10, 2009 02:06
Finding the node temperature (not cell)	Parsa Zamankhan	FLUENT	4	August 22, 2007 16:38
How do I set lower temperature boundary limit?	Arefin Anwar	CFX	1	December 4, 2006 10:48
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15
drastic increase of temperature in one cell	ravi	FLUENT	7	August 30, 2004 23:58

All times are GMT -4. The time now is 02:11.