Setting BC for interior surface -- CFD Online Discussion Forums

January 7, 2006, 01:22	Setting BC for interior surface	#1
Leo Guest Posts: n/a	I would like set a specific UDS BC at a specific interface between two regions (interior). Is it possible to do that using DEFINE_PROFILE or DEFINE_ADJUST? Need some advices. Thanks.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 22:58
Sover setting with TUI	junbbung	FLUENT	0	August 20, 2009 01:43
LiftDrag utility from v12 to v141	cfdphil	OpenFOAM Running, Solving & CFD	2	December 5, 2007 06:49
Ultra high temperature?	bk	Siemens	2	July 19, 2005 01:01
Warning 097-	AB	Siemens	6	November 15, 2004 05:41

All times are GMT -4. The time now is 14:11.