HOW TO DOING INJECTION

December 24, 2005, 06:31

HELLO I DOING INJECTIO. I DOING FIRST LAMINAR AND TARBULENT WITH WITH SMALLER HOLE OF 9.525MM DIA FOR FUEL AND 350MM DIA FOR AIR.AIR AND FUEL IS SUPLY AT 0.635M/S AND 0/0975 M/S IN BOUNDARY CONDTION.BOTH LAMINAR AND TARBULENT ARE CONVERGE. IF I WANT TO INJECTION THEN WAHT VELOCITY AND DIA IS GIVEN IN INJECTION SETTING AND WHAT VELOCITY IS GIVEN IN BOUNDARY CONDITION FOR FUEL. THANKING YOU

December 25, 2005, 04:00

Study User Manual about spray then use one of them

December 27, 2005, 05:10

thanks but i read manual but there is so many parameter selected and so many confusion. Please give some refrence. manojkumar

December 24, 2005, 06:31	HOW TO DOING INJECTION	#1
MANOJKUMAR Guest Posts: n/a	HELLO I DOING INJECTIO. I DOING FIRST LAMINAR AND TARBULENT WITH WITH SMALLER HOLE OF 9.525MM DIA FOR FUEL AND 350MM DIA FOR AIR.AIR AND FUEL IS SUPLY AT 0.635M/S AND 0/0975 M/S IN BOUNDARY CONDTION.BOTH LAMINAR AND TARBULENT ARE CONVERGE. IF I WANT TO INJECTION THEN WAHT VELOCITY AND DIA IS GIVEN IN INJECTION SETTING AND WHAT VELOCITY IS GIVEN IN BOUNDARY CONDITION FOR FUEL. THANKING YOU

December 25, 2005, 04:00	Re: HOW TO DOING INJECTION	#2
nasser Guest Posts: n/a	Study User Manual about spray then use one of them

December 27, 2005, 05:10	Re: HOW TO DOING INJECTION	#3
MANOJKUMAR Guest Posts: n/a	thanks but i read manual but there is so many parameter selected and so many confusion. Please give some refrence. manojkumar

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
surface injection or point injection?	sukura_1984	FLUENT	0	September 2, 2009 10:26
Urgent help needed with spray injection	nick	Siemens	14	June 29, 2008 19:48
On DPM injection properties.	akr	FLUENT	4	October 23, 2006 11:54
DPM, UDF, Injection Type	Zhang	FLUENT	0	June 8, 2005 16:51
using injection file and parallel process	Cindy Jones	FLUENT	0	January 23, 2003 13:40