|
[Sponsors] |
November 26, 2005, 22:00 |
Wall adhesion
|
#1 |
Guest
Posts: n/a
|
Dear All,
Is it possible for Fluent v6.2 to simulate VOF problems with the consideration of wall adhesion? If yes, how to specify the contact angle? Thank you very much in advance. Rucy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 00:04 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |