 |
 |
 |
|
|
|
[Sponsors] | ||||
November 14, 2005, 13:57
|
interface
|
#1 |
|
Guest
Posts: n/a
|
After initial the model, the system tells the following warn.
WARNING: Unassigned interface zone detected for interface 6 Error: Init_Flow: unassigned interface_zones Error Object: () What happen? How to change it? Thank you! |
|
|
||
|
November 15, 2005, 02:58
|
Re: interface
|
#2 |
|
Guest
Posts: n/a
|
If ur interface contain periodic surface; check on periodic in interface panel.......... If interface contain two different fluids or solid-fluid interface, plz check on coupled in interface panel. hope it will be helpful..........
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
Linear Mode
