|
[Sponsors] |
Gambit boundary conditions not suitable for fluent |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi
Really need some help on gambit here. When I apply pressure outlet and pressure inlet boundary conditions to the 2 ends of my 2D model and tries to export the mesh, error message says boundary condition specified is invalid for fluent 6. Can anyone help? My model is a converging duct with a straight duct connected. thanks a lot. ann |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
selce FLUENT as your solver while you are exporting your mesh. This might be one of the reasons that u are facing the problem. I am not sure but hope it will provide you with some pointers.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
I have managed to solve the problem by selecting export 2d xy mesh in the export dialogue box besides entering the file name. Thanks.
ann |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Try to trace down the problem by checking whether you are selecting the 2D export function or not, or any other operating mistakes. If fluent allows you to select those boundary condition, it is really a small possibility that those boudary condition not suitable for fluent.
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 05:58 |
Boundary Conditions in Gambit for a dam break model | Lindsey | FLUENT | 2 | October 5, 2009 02:53 |
Help with boundary conditions | Dan | CFX | 0 | April 3, 2006 11:32 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 01:54 |