|
[Sponsors] |
October 10, 2005, 02:49 |
total number of cells changes !!!!
|
#1 |
Guest
Posts: n/a
|
Hi, everyone. Why is that the total number of cells changes when I imported mesh from ICEM to FLUENT? But in FLUENT when I check the grid there is no problem, how could that happen? the total nodes and cells changes greatly. the original mesh is of about 0.6 million cells and after being imported into Fluent it is 0.56 million. is that because FLUENT seperate some single boundary faces into multiple faces? I would appreciate it if you give me your advice.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to let the mesh motion solver just solve a small region near a moving boundary? | zhajingjing | OpenFOAM Running, Solving & CFD | 9 | April 28, 2016 05:15 |
[snappyHexMesh] Prediction of Number of Cells | Balakrshnan Ramakrishnan | OpenFOAM Meshing & Mesh Conversion | 0 | April 27, 2011 04:57 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
SOS! HELP! max number of cells :( | Jas | Phoenics | 4 | February 14, 2004 11:12 |