|
[Sponsors] |
September 10, 2005, 08:46 |
Electric arc furnace
|
#1 |
Guest
Posts: n/a
|
I am a student of M.Sc. of mechanical engineering. my thesis is about simulating the heat transfer in electric arc furnace and i should simulate the arc at first. i want to use FLUENT commercial code to do this but i don't know can i use the MHD module for modelling the arc or not. I would appreciate any suggestions regarding my thesis. thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 6 | June 19, 2017 15:12 |
Electric arc fault | chandu | CFX | 8 | August 24, 2012 08:44 |
[blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 0 | April 7, 2011 12:09 |
weird error during blockMesh | SePe | OpenFOAM | 1 | October 25, 2010 11:31 |
Electric arc furnace modeling.. | Divyang Shah | Main CFD Forum | 11 | June 22, 1999 14:29 |