|
[Sponsors] |
September 7, 2005, 00:16 |
Doubt - while running iteration, plz help
|
#1 |
Guest
Posts: n/a
|
Hi All
iam solving the heat transfer flow in spiral fluted tube, i have a doubt like while running iteration the messege is displaying as " turbulent viscosity limited to viscosity ratio of 1.000000e+05 in ----cells, the --- indicates the number of cells. its continously displaying with increasing number of cells. I dont know what the error is, is that becose my boundary condition are not properly set up or is that related to mesh. plz help with this matter, any suggestion are highly appreciated thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Statically Compiling OpenFOAM Issues | herzfeldd | OpenFOAM Installation | 21 | January 6, 2009 10:38 |
A basic doubt on reading the iteration results | hariya03 | OpenFOAM Post-Processing | 0 | July 16, 2008 09:28 |
Kubuntu uses dash breaks All scripts in tutorials | platopus | OpenFOAM Bugs | 8 | April 15, 2008 08:52 |
error while running iteration | Rajavel | FLUENT | 2 | December 17, 2007 07:05 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 23:30 |