|
[Sponsors] |
August 30, 2005, 15:40 |
Transient simulation
|
#1 |
Guest
Posts: n/a
|
Hi. I am an Airpak User. I am simulating a transient case to investigate concentration changes of two contaminants (H2S and CO2) over 20 minutes. There is no change in air flows (velocity) but I want to see how the contaminants are decaying from a certain concentrations by the ventilation.
My question is that if Aipak can simulate the decaying case only with ventilation condition, initial concentraitons and configulation of the room. If it is possible, would you please give me some advice for that? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
about transient radiations simulation | waradevivek | FLUENT | 0 | October 17, 2011 11:16 |
Beginning a Transient Simulation | Norflow | CFX | 2 | October 7, 2011 01:38 |
initial conditions for transient simulation | littlelz | CFX | 2 | February 5, 2009 06:56 |
Transient simulation - pressure shifted | Eric | CFX | 1 | February 14, 2006 13:42 |
Charts for transient simulation | Anurag | CFX | 2 | March 28, 2005 13:09 |