Gambit meshing

August 30, 2005, 08:10

Hello! Is it possible to connect two volumes using hex map, where one of the volumes is a cilinder and the other rectangle.

Thank,you

August 30, 2005, 09:05

Dear Bodgan:

Yes it is possible. You can create, mesh and save these two volumes separately as .msh files. Then use tmerge utility to connect them. tmerge utility is in the adress c:\fluent.inc\untility\tmerge2.1\ntx86\...

you can use 2D and 3D versions based on your model. First input the smaller mesh file name and then the second. tmerge creates one mesh file with connected volume.

Best Regards Mehdi Ghoddosy

August 30, 2005, 08:10	Gambit meshing	#1
bogdan Guest Posts: n/a	Hello! Is it possible to connect two volumes using hex map, where one of the volumes is a cilinder and the other rectangle. Thank,you

August 30, 2005, 09:05	Re: Gambit meshing	#2
Mehdi Ghoddosy Guest Posts: n/a	Dear Bodgan: Yes it is possible. You can create, mesh and save these two volumes separately as .msh files. Then use tmerge utility to connect them. tmerge utility is in the adress c:\fluent.inc\untility\tmerge2.1\ntx86\... you can use 2D and 3D versions based on your model. First input the smaller mesh file name and then the second. tmerge creates one mesh file with connected volume. Best Regards Mehdi Ghoddosy

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 06:59
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 06:22
[GAMBIT] Desperate student needs help meshing 3D GAMBIT model - please help!	lau06165	ANSYS Meshing & Geometry	1	March 22, 2010 02:09
Meshing problem in GAMBIT	Vidya Raja	FLUENT	0	May 21, 2006 00:31
Meshing Aircraft with Gambit	Ed	FLUENT	5	November 9, 2004 06:04