Refine mesh error

July 24, 2005, 23:31

When I try to refine the mesh in Gambit and read it in Fluent, it gives me this message

Building...

grid, face[187358]->cell1[-1] on thread 11 out of range (0<=cell<94169). Error: Build_Grid: grid error.

Clearing partially read grid.

Error: FLUENT received fatal signal (ACCESS_VIOLATION) 1. Note exact events leading to error. 2. Save case/data under new name. 3. Exit program and restart to continue. 4. Report error to your distributor. Error Object: ()

Can someone help me solve this problem.

Thanks.

Sham

July 25, 2005, 10:16

Usually this means the file was corrupted... I get this sometimes, and I re-write the mesh file and it fixes the problem. Also, if you are transferring the file, sometimes the wrong transfer protocal is used and data gets cut off, so be careful of that too.

Hope this helps, and good luck, Jason

July 24, 2005, 23:31	Refine mesh error	#1
Sham Guest Posts: n/a	When I try to refine the mesh in Gambit and read it in Fluent, it gives me this message Building... grid, face[187358]->cell1[-1] on thread 11 out of range (0<=cell<94169). Error: Build_Grid: grid error. Clearing partially read grid. Error: FLUENT received fatal signal (ACCESS_VIOLATION) 1. Note exact events leading to error. 2. Save case/data under new name. 3. Exit program and restart to continue. 4. Report error to your distributor. Error Object: () Can someone help me solve this problem. Thanks. Sham

July 25, 2005, 10:16	Re: Refine mesh error	#2
Jason Guest Posts: n/a	Usually this means the file was corrupted... I get this sometimes, and I re-write the mesh file and it fixes the problem. Also, if you are transferring the file, sometimes the wrong transfer protocal is used and data gets cut off, so be careful of that too. Hope this helps, and good luck, Jason

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 19:00
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
c++ libraries and solver compiling	vaina74	OpenFOAM Installation	13	February 3, 2012 18:43
ParaView for OF-1.6-ext	Chrisi1984	OpenFOAM Installation	0	December 31, 2010 07:42
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55