help me for dynamic mesh

speedcat

Hi I'm having trouble getting the UDF DEFINE_GEOM to work properly. I would like to use the UDF to make the bottom of a rectangular duct with air blowing deform into a different shape over time. I have compiled the UDF properly and have hooked it into fluent as outlined in the UDF user's manual. However, when I view the mesh motion, the bottom does not deform.

I'm having trouble getting the UDF DEFINE_GRID_MOTION to work properly, too. I have compiled the UDF properly and have hooked it into fluent as outlined in the UDF user's manual. However, when I define the zone of the dynamic mesh, an error of ¡°incorrect geometry udf gg on zone 6 (assuming no geometry )¡±. The bottom is zone whose ID is 6.

I would really appreciate your help. My e-mail is sxy_hit@163.com

My project is shown as follow. I will give you some file about my problem and the UDF of DEFINE_GEOM and DEFINE_GRID_MOTION.Thank you!

The bottom of the duct is from (-5,-2.5) to (-5,2.5). the new position is defined by a parabola through (-5,-2.5), (0,-2.4) and (-5,2.5). The parabola is

DEFINE_GEOM:

/************************************************** *** * * defining parabola through points (-5,-2.5), (0,-2.4),(5,-2.5) * ************************************************** ***/ #include "udf.h"

DEFINE_GEOM(parabola,domain,dt,position)

{

/*set y=-0.004x^2-2.4*/

position[1]=-0.004*position[0]*position[0]-2.4;

}

DEFINE_GRID_MOTION

/************************************************** *** * * defining parabola through points (-5,-2.5), (0,-2.4),(5,-2.5) * ************************************************** ***/ #include "udf.h"

DEFINE_GRID_MOTION(gg, domain, dt, time, dtime)

{

Thread *tf = DT_THREAD (dt);

face_t f;

Node *v;

int n;

SET_DEFORMING_THREAD_FLAG(THREAD_T0(tf));

begin_f_loop (f, tf)

{

f_node_loop (f, tf, n)

{

v=F_NODE (f, tf, n);

if (NODE_POS_NEED_UPDATE (v))

{

NODE_POS_UPDATED (v);

NODE_Y(v)=-0.004*NODE_X(v)*NODE_X(v)-2.4;

}

}

}

end_f_loop (f, tf);

}