 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2005, 05:09
|
ERROR!!
|
#1 |
|
Guest
Posts: n/a
|
I keep getting the error: TEMPERTAURE LIMITED TO 1 When does this occur and why??
|
|
|
||
|
May 9, 2005, 05:28
|
Re: ERROR!!
|
#2 |
|
Guest
Posts: n/a
|
temperature limited to 1k means fluent has calculated a negative kelvin temperature. this makes no sense an therefore the lower temperature limit is used instead of the calculated value. you can set the limit for temperature, pressure etc. in solve->sontrol->limits. why does it occur? its hard to say. i observed this message sometimes during combustion modeling with an negative heat flux as wall bc.
rom |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 18:43 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 21:30 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |
| user defined function | cfduser | CFX | 0 | April 29, 2006 11:58 |
Linear Mode
