|
[Sponsors] |
April 26, 2005, 09:50 |
Patch-Different values to different zones
|
#1 |
Guest
Posts: n/a
|
Hi I am trying to solve fluid flow through a porous medium. For this i have got two different zones ( two different porous medium zones with different properties). I need to patch different values of discreet particle phases to the two zones. I have tried to use initialise->patch and patch one value to one particular zone. But after doing this i find that the value has been patched to the other zone also. I tried to use region->mark and again i get the same value in the whole domain.
Is there any way that i can give different initial values to the two zones? I would really appreciate some advise on this. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TimeVaryingMappedFixedValue | irishdave | OpenFOAM Running, Solving & CFD | 32 | June 16, 2021 07:55 |
HELP NEEDED HOW TO MAP VALUES FROM PATCH OF ONE MESH TO PATCH OF ANOTHER MESH | mkraposhin | OpenFOAM Running, Solving & CFD | 3 | September 4, 2011 10:42 |
Adding imaginary patch for calculation of average values | bboonacker | OpenFOAM Running, Solving & CFD | 4 | June 2, 2009 00:00 |
Retrieving boundary patch values adjacent to a given cell | brooksmoses | OpenFOAM Post-Processing | 2 | December 8, 2008 11:00 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 09:19 |