 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2005, 15:43
|
Modelling combustion and heat transfer
|
#1 |
|
Guest
Posts: n/a
|
How can I simulate the combustion using a pdf mixture and, in the same time, the heat transfer between the exhaust hot gases and water through a wall? I ask this because when you have a pdf mixture for non-premixed combustion in Fluent 6.2 you can't use a massflow-inlet of a fluid that isn't a part of the mixture, like liquid water. If there is a solution please let me know! Thank's!
|
|
|
||
|
April 24, 2005, 04:31
|
Re: Modelling combustion and heat transfer
|
#2 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
April 27, 2005, 11:55
|
Re: Modelling combustion and heat transfer
|
#3 |
|
Guest
Posts: n/a
|
Did not quite get your Question. Can you explain a little more?
|
|
|
|
||
|
May 1, 2005, 10:08
|
Re: Modelling combustion and heat transfer
|
#4 |
|
Guest
Posts: n/a
|
You could possibly use the two mixture fraction PDF model, with the second mixture being water. However, it might be better to use the ED model instead.
|
|
|
|
||
|
May 9, 2005, 08:02
|
Re: Modelling combustion and heat transfer
|
#5 |
|
Guest
Posts: n/a
|
Hi; To what extend chemistry is important in your case?It is quite better to switch from PDF to EDC if the reduced mechanism is available.Please let me know what sort of fuel are you using for your simulation. Regards
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 09:56 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 13:02 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
Linear Mode
