UDS and wall treatment

March 25, 2005, 22:37

Hello everyone,

I want to add my own wall function to the wall boundaries by using UDS. Could anybody help me on this point? How to do it? I am not familar with C plus. Any good suggestions? Thanks a lot.

Zwdi

March 30, 2005, 15:50

Any help? Thanks.

zwdi

March 31, 2005, 15:57

If you want to implement your wall boundary condition, you need to use the DEFINE_PROFILE macro, and apply your UDF to the wall boundary condition.

Look for DEFINE_PROFILE in the UDF manual. There are many examples.

Best regards, ap

March 25, 2005, 22:37	UDS and wall treatment	#1
zwdi Guest Posts: n/a	Hello everyone, I want to add my own wall function to the wall boundaries by using UDS. Could anybody help me on this point? How to do it? I am not familar with C plus. Any good suggestions? Thanks a lot. Zwdi

March 30, 2005, 15:50	Re: UDS and wall treatment	#2
zwdi Guest Posts: n/a	Any help? Thanks. zwdi

March 31, 2005, 15:57	Re: UDS and wall treatment	#3
ap Guest Posts: n/a	If you want to implement your wall boundary condition, you need to use the DEFINE_PROFILE macro, and apply your UDF to the wall boundary condition. Look for DEFINE_PROFILE in the UDF manual. There are many examples. Best regards, ap

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
match uds flux value between wall and wall_shadow	pour	FLUENT	1	October 26, 2020 23:05
UDS problem with wall boundary condition	Alex F.	FLUENT	15	September 21, 2015 10:28
Wall Treatment of User defined Turbulence Model	Yang Chung	FLUENT	0	August 23, 2008 12:31
match uds boundary condition in wall & wall-shadow	pour	FLUENT	0	May 20, 2008 09:56
UDS flux through wall and interior face.	shuqin	FLUENT	2	July 29, 2006 04:54