|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello friends, I am trying to create eccentric annulus in 3D.I am creating outer and inner cylinder and moving inner cylinder for eccentricity and the subtracting inner cylinder from outer to get eccentric annulus. after meshing faces and whole volume and specifying boundary conditions and velocity inlet and pressure outlet the mesh is exported to Fluent. In Fluent (selcted "Run fluent in 3D" at the begining of Fluent), when read case file the created it gives me error like " Error: no cells in zone, id = 0, ind1 = 1, indn = 0Reading Cells: failed while reading section 12.
Clearing partially read grid. Error: Read aborted due to critical error. Error Object: ()" Any help is appreciated Parag |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model | Jonas Larsson | FLUENT | 5 | March 13, 2000 03:27 |