|
[Sponsors] |
March 14, 2005, 08:35 |
convergence criteria
|
#1 |
Guest
Posts: n/a
|
Hello
i am modelling (Mixture model) two phase flow (air-water) in vertical pipe with velocity inlet for water and air and pressure outlet for mixture at the exit. i have some results but they donot show any convergence, specially continuity equation does not decrease below 10-3 while rest goes to 10-4. How should i ensure whether the results i obtained are converged. I still need to perform the experiments so i dont have actual results. I am thinking of using monitoring mass flow rate of the mixture at the oulet on the top or should i use target massflow rate. Advice needed. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Force can not converge | colopolo | CFX | 13 | October 4, 2011 23:03 |
What value shall I set for the Convergence criteria? | steventay | CFX | 7 | May 14, 2010 13:44 |
Convergence criteria | PrandtlGlawert | FLUENT | 1 | August 13, 2009 19:06 |
Convergence Criteria | edwin | FLUENT | 1 | February 14, 2008 20:24 |
Convergence criteria | Gaurav | Siemens | 0 | February 3, 2006 05:53 |