|
[Sponsors] |
March 8, 2005, 06:29 |
How to creat mesh in Gambit for airfoil
|
#1 |
Guest
Posts: n/a
|
hi,Everyone
i sanjay umarani doing my PG-in enginering analysis & design, as a part of my study i have to do project work. I have doing my project in CFD analysis of wind tubine airfoil design. I used eppler code to genert the x-y coordinates. In this i have facing some proble to generate the airfoil in Fluent 1) the coordinate points of upper & lower are not equel ? for example -1098 airfoil of 61 cordinates 2) while meshing some c-gird type mesh to be created in that case the element points are not matching it is giving upper 36 & lower 35 it shoud not to be happened in fluent but givien that error why ? if any one know this regard plesae tell me to what is wrong in this case i have waiting your reply sanjay |
|
March 8, 2005, 08:22 |
Re: How to creat mesh in Gambit for airfoil
|
#2 |
Guest
Posts: n/a
|
HI:
Have a look at: http://instruct1.cit.cornell.edu/courses/fluent/ It shows how to mes an airfoil Miguel |
|
March 8, 2005, 23:54 |
Re: How to creat mesh in Gambit for airfoil
|
#3 |
Guest
Posts: n/a
|
thanks for your reply
i have used the same site & same proble. But the co-ordinate i took was genrated by Eppler Code, in this case it is around 33 upper & 29 lower, if you make correction by making equal points, is their any change of shape will occure or what i have taken is correct i dont now. After all correcting the co-oridante if you go head the it is giving meshing problem. As of my knowledg the mesh element should be equeal. but in this case it is giving upper -76 & lower - 75 is it correct ? if you know about plesae help me by sanjay |
|
March 15, 2005, 04:14 |
Re: How to creat mesh in Gambit for airfoil
|
#4 |
Guest
Posts: n/a
|
Using Gambit, try to import your Eppler coordinate using ICEM Input.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
3-D Mesh Check in Gambit..... | SHR | FLUENT | 4 | March 25, 2003 04:10 |