 |
 |
 |
|
|
|
[Sponsors] | ||||
February 15, 2005, 10:43
|
2D Wing Problem
|
#1 |
|
Guest
Posts: n/a
|
Hi There,
I am modelling a power kite in 2D. When I plot a graph of pressure coefficient along the upper and lower surfaces of the kite the values are out by a factor of 100 (+) Anybody have any suggestions as to why this is? Or how to solve this? Thanks, Rich |
|
|
||
|
February 15, 2005, 11:24
|
Re: 2D Wing Problem
|
#2 |
|
Guest
Posts: n/a
|
You should set the correct references value like surface, chord etc. Look under report/reference values. Luca
|
|
|
|
||
|
February 15, 2005, 12:34
|
Re: 2D Wing Problem
|
#3 |
|
Guest
Posts: n/a
|
Luca thanks....my problem was just that. I hadn't set a reference pressure, Thanks
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
| Problematic Geometry | fatb0y | CFX | 15 | October 13, 2010 18:17 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 15:52 |
Linear Mode
