UDF velocity profile problem -- CFD Online Discussion Forums

January 18, 2005, 13:11	UDF velocity profile problem	#1
Steve Guest Posts: n/a	Hi, When setting a velocity profile that contains zero values on an inlet plane I run into problems with tke and epsilion profiles on that same plane. The tke and epsilon profiles are also set using a UDF, however for the regions where the velocity is set to zero, the values of tke and epsilon do not agree with the set values in the UDF. "Banding" occurs where I get multiple values along the inlet plane. Since I set these profiles with a UDF on the whole plane, I do not understand why the values should change. Have you seen this before? Is there a fix? Thanks for your time! Steve

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[UDF] Relative coordinates in logarithmic velocity profile	cfdworker	Fluent UDF and Scheme Programming	25	July 13, 2017 04:44
UDF for 3d inlet parabolic velocity profile ?	shahzeb irfan	Fluent UDF and Scheme Programming	10	March 28, 2016 16:00
UDF velocity and temperature	Raj	FLUENT	3	February 1, 2009 19:29
UDF velocity profile at nodes	Emad	FLUENT	2	January 29, 2009 07:35
UDF for Velocity profile in 3D rectancular duct	Emad	FLUENT	0	January 21, 2009 04:11

All times are GMT -4. The time now is 04:38.