How to report the particle trajectory to a file -- CFD Online Discussion Forums

January 11, 2005, 10:26	How to report the particle trajectory to a file	#1
Devy Guest Posts: n/a	I am using discrete phase modeling to simulate the particle trajectory. I have a question regarding how to save the particle trajectory to a file. Since I use the surface injection, that means around 200 particles will be injected from the inlet surface.In the DPM the Maximum number of steps was set as 50000. Then I used udfs to write trajectory report of a plane to a file. It turns out there are only 19 particles in the file. Where are the other particles' varible? How can I write all the particles in the plane to a file? If anybody has a idea, please let me know. Thank you very much! good luck, Devy

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Working directory via command line	Luiz	CFX	4	March 6, 2011 21:02
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 18:18
paraview installation woes	vex	OpenFOAM Installation	15	January 30, 2011 08:11
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3	flakid	OpenFOAM Installation	16	December 28, 2010 09:48
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 07:51

All times are GMT -4. The time now is 21:01.