|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hey everyone! I am having problems exporting my mesh from gambit into fluent. fluent is consistently giving me the message "Note: Separating wall zone 3 into zones 3 and 1. all -> wall (3) and wall:001 (1)Removing 2884 unreferenced faces, zone 1." What am I doing wrong and do you have any ideas on how I can fix it? Thanks!
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Regarding the first message, I think this usually happens when you define faces that are not adjacent as one zone ("wall" in your case). If you want to avoid that you have to define the faces in separate zones in Gambit. You can go on with the separated zones but it can become confusing because of the nomenclature. I cannot help you with the removing of unreferenced faces.
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Gambit to Fluent error: can't upload Brain Mesh | EphemeralMemory | ANSYS Meshing & Geometry | 2 | September 26, 2010 22:12 |
mesh missing after export in gambit | morteza08 | Main CFD Forum | 0 | July 23, 2010 02:19 |
exporting from Fluent back into Gambit | tom | FLUENT | 0 | June 23, 2008 16:55 |
Problems with exporting Gambit mesh to Fluent | Alex Mozharov | FLUENT | 4 | November 24, 2002 01:17 |