|
[Sponsors] |
November 16, 2004, 19:23 |
change of boundary conditions
|
#1 |
Guest
Posts: n/a
|
Hi guys, I'm modelling an hole in a thick wall whit a flow through. At x-time, the hole become wider. How can I stop the simulation, change the boundary shapes, and restart it? Thanks, luca.
|
|
November 22, 2004, 10:55 |
Re: change of boundary conditions
|
#2 |
Guest
Posts: n/a
|
Interesting to know how it is possible. So it is unsteady calculation. Now, the question is how to widen the hole diameter during the calculation.Or is it that the diameter of hole changes only at perticular time x?
|
|
November 22, 2004, 11:31 |
Re: change of boundary conditions
|
#3 |
Guest
Posts: n/a
|
It would be just a valvle: initially close, and open after that pression gets a particular value. At this moment, it's not important to represent opening phase (later, we'll see...), I just want to understand if it' possible to change geometry and restart iteration.
Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 13:58 |
non reflective boundary conditions for incompresible flow | Pascal_doran | OpenFOAM Programming & Development | 16 | August 25, 2015 06:35 |
How to change the nature of boundary conditions ? | Bedotto | ANSYS Meshing & Geometry | 3 | August 6, 2010 01:12 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 07:25 |