 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2004, 11:02
|
Valve boundary conditions
|
#1 |
|
Guest
Posts: n/a
|
I am modelling water flow through valves using Fluent to find out the throttling characteristics.Basicaly I would like to know what will the mass flow rate for various valve openings.Assuming that the pipe incorporating the valve being connected to a centrifugal pump on one side and open to the atmosphere on the other end, what type of boundary conditions should I give for different valve positions.
Thanking you. |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 13:58 |
| natural convection | mehrdadeng | CFX | 10 | February 25, 2011 06:25 |
| CFX does not continue | Shafiul | CFX | 10 | February 17, 2011 08:57 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
| Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 07:25 |
Linear Mode
