 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2004, 21:28
|
tank leakage
|
#1 |
|
Guest
Posts: n/a
|
I have a big cylindrical tank (used to store grain in grain elevators) . Gas gets collected in the headspace of the tank. The tank is exposed to environmental conditions. Since the tank has vents at top, due to wind etc. often lot of gas in the tank headspace leaks out from the tank. How do I simulate this effect in fluent? CAn I put some mass , momentum sinks etc. ?
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| interFoam / bubbleFoam to simulate an aerated tank | Meratb | OpenFOAM Running, Solving & CFD | 3 | November 6, 2020 12:45 |
| Filling Tank with Water | leff | CFX | 7 | August 21, 2017 08:47 |
| boundary condition for a gassed agitated tank | fiona | Main CFD Forum | 4 | March 23, 2010 11:27 |
| Blow Tank Simulation ... Need Help! | treyevans | CFX | 1 | February 20, 2010 01:42 |
| how to maintain constant presure in a tank? | JB | FLUENT | 5 | July 31, 2008 06:12 |
Linear Mode
